Just downloaded the Beta Build 876 and am working through the tutorial, but have come to a grinding halt when I can't seem to expand the number of levers in the frame from six. I've tried a few things like completely re-starting the application, and trying to insert levers using the right click on the lever panel, but no luck.
Jim.
Can't enlarge lever frame from default six levers.
Moderator: RedFred
-
- Posts: 3
- Joined: Mon Mar 08, 2004 3:04 am
- Location: uk
- Contact:
Re: Can't enlarge lever frame from default six levers.
Found the same thing. The insert/delete lever comands are clever but take some getting used to. You need to have a working lever on the right hand end of the frame (i.e working levers are painted any other color except white [which is spare] - use h key while lever selected to change). Then use insert key to move that working lever to the right one slot. If the frame needs more levers to move the working lever to the right it will add a further bank of 6. Insert/delete moves ALL levers to the right of the lever selected even after connections to track objects have been defined - diagram numbering is adjusted automatically in this case. This is bound to come in handy to make space for those points forgotten or added in later perhaps! If you had already defined routes before moving connected levers about, you would need to clear routes one by one and do again to rebuild the interlocking.JimG wrote: . . .I can't seem to expand the number of levers in the frame from six. . .
Are we nearly there yet?
Cannot add levers to basic 6
I downloaded v1.0 beta 15 March 04. I tried the tutorial and then thought I could branch out and try out my pet layout. In both cases I could get as far as drawing the track plan and locating signals. HOWEVER, in neither case could I increase the number of levers beyond six. Help!!
Alex
Alex
Alex,
As you can see from other posts, there was a problem that was fixed at build ID 877. That build was actually uploaded on 15/3 but you may have downloaded before the change. Check the build ID of your SigScribe4 - it's shown when you access Help > About. I suspect you are using 876. If so, just download the current build (883) .
As you can see from other posts, there was a problem that was fixed at build ID 877. That build was actually uploaded on 15/3 but you may have downloaded before the change. Check the build ID of your SigScribe4 - it's shown when you access Help > About. I suspect you are using 876. If so, just download the current build (883) .
All the best from "modadmin"
Forum Administration
MODRATEC
Forum Administration
MODRATEC