Lever Throw

Announcements, comments and hints about MODRATEC Lever Frame Kits

Moderator: RedFred

Post Reply
User avatar
RedFred
Top Link
Top Link
Posts: 38
Joined: Thu Jan 15, 2004 1:09 pm
Location: Queensland, Australia

Lever Throw

Post by RedFred »

The standard drilling of Levers provides for throws of 4mm and 8mm Pull and Push. (There are two holes above the fulcrum and two below.)

Note that the first version of our kits provided throws of 3mm and 5mm.

Users may decide to adopt a non-standard drilling, but 8mm is the maximum practical throw.
Happy training,
RedFred
The MODRATEC Moderator
Post Reply