Double Slips

Add your comments and questions about the mechanical control of model railway signals and points particularly by the WIT (wire-in-tube) method.

Moderator: RedFred

Post Reply
corpach
Posts: 1
Joined: Mon Aug 25, 2008 11:48 am

Double Slips

Post by corpach »

Us modellers tend to use a single tie-bar at either end of a slip to connect the four blades involved. Is this the case with the prototype? How many levers would be involved to set a route?
User avatar
RedFred
Top Link
Top Link
Posts: 38
Joined: Thu Jan 15, 2004 1:09 pm
Location: Queensland, Australia

Post by RedFred »

The typical arrangement you suggest in the model is certainly one of the legitimate real-life configurations. There can be reasons to control each pair of points at one end of a double slip independently, but that is certainly not the most common, at least by my observation of British and related practice. Hence, two levers per double slip is the usual standard. But, having said that, it is quite common for a double (or single) slip to be associated with a set of points in a crossover-like combination. In such a situation the points would generally co-act with the remote end of the slip, and that type of pairing would continue in any ladder of slips. So if we consider a ladder of points/slip/slip/points, these would be controlled by 3 levers (call them A, B, C) in the following sequence - A/BA/CB/C.
Happy training,
RedFred
The MODRATEC Moderator
tux
Top Link
Top Link
Posts: 14
Joined: Mon Feb 04, 2008 4:03 pm

Post by tux »

Anywhere between 1 and 4 levers could be seen in real life, with 2 and 4 being the most common.

I have taken photos of a double-slip in a yard in Melbourne with hand levers using just two levers.
Post Reply