MODRATEC Guest Lounge

AndrewIC · Joined: 09 Aug 2005 Posts: 8

I want to control my turnouts from a MODRATEC frame using Wire-in-Tube - so far so good.

But I need to control just a couple of turnouts electrically, because I don't want to run WiT across a baseboard join. Can I do this with the optional MODRATEC switches? Usually I would control electric point motors with an electric pencil or a passing contact switch and a CDU.

Any ideas would be welcome!
Andrew

RedFred · Posted: Wed Aug 10, 2005 6:50 am Post subject:

AnrewIC, have a look at the following article on the MODRATEC web site:

http://MODRATEC.com/mud_points.php

Also note that by using the MODRATEC point-wit, it is quite practical to run mechanical links across baseboard joins. Check out:

http://MODRATEC.com/wit.php
_________________
Happy training,
RedFred
The MODRATEC Moderator

AndrewIC · Joined: 09 Aug 2005 Posts: 8

Thanks, I spotted that page just after posting the question Embarassed

Useful circuits, thanks very much.

Andrew